[. . . ] Also, rear displays should not be in a location where it is a visible distraction to the driver. In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. NEVER install the display in a location that enables the driver to watch the DVD or Video CD while driving. ! [. . . ] OFF ­ No auxiliary device is connected Switching the auxiliary 2 setting 1 Use MULTI-CONTROL to select AUX2. 2 Press MULTI-CONTROL to turn AUX2 on. # To turn AUX2 off, press MULTI-CONTROL again. Switching the warning tone If the front panel is not detached from the head unit within five seconds of turning off the ignition, a warning tone will sound. 2 Press MULTI-CONTROL to turn warning tone on. # To turn warning tone off, press MULTI-CONTROL again. Setting the AV input You can connect AV components to the AV input with an RCA cable. Select EXT-V to watch video of a connected video unit as EXT source. Switching the auxiliary setting Auxiliary devices connected to this unit can be activated individually. For more information about En 49 Section 02 Operating this unit !Select CAMERA to watch a rear view camera video while you are backing your vehicle. EXT-V ­ External video unit (such as Pioneer products available in the future) !CAMERA ­ Rear view camera # To watch video of AUX source, set auxiliary 2 setting on. For details, refer to Switching the auxiliary setting on the previous page. # If AV system display (e. g. , AVX-7650) is combined with this unit, connect the rear view camera to the AV system display. For details concerning connection methods, refer to AV system display's instruction manual. SLA (source level adjustment) setting (refer to Adjusting source levels on page 67) !Dynamic range control (refer to Using the dynamic range control on page 67) !Direct control setting (refer to Using the direct control on page 67) !Down-mix setting (refer to Using the downmix function on page 67) 1 Use MULTI-CONTROL to select AUDIO RESET. 2 Press MULTI-CONTROL to display OK. Other Functions Turning the clock display on or off You can turn the clock display on or off. Each press of CLOCK turns the clock display on or off. # The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds. Note Even when the sources are off, the clock display appears on the display. Pressing CLOCK turns the clock display on or off. # To cancel resetting the audio functions, press BAND. 3 Push MULTI-CONTROL right to display REALLY?. # To cancel resetting the audio functions, press BAND. Switching the display indication and button illumination Display indication and button illumination can be switched on or off. Pressing and holding DISP OFF switches the display indication and button illumination on or off. # While the display indication is turned off, CLOCK/DISP OFF button lights up. # Even if the display indication is turned off, operation can be conducted. If operation is conducted while the display indication is off, display will light up for a few seconds and then turn off again. 4 Press MULTI-CONTROL to reset audio functions. [. . . ] DVD video, Video CD, CD, CD-R/RW, DVD-R/RW Signal format: Sampling frequency . . . . . 44. 1/48/96 kHz Number of quantization bits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Hz to 44 000 Hz (with DVD, at sampling frequency 96 kHz) Signal-to-noise ratio . . . . . . . . . . . . . . . 97 dB (1 kHz) (IEC-A network) (CD: 96 dB (1 kHz) (IEC-A network)) Number of channels . . . . . . . . . . . . . . [. . . ]